Stainless Steel Tail Drive System For 20 Mm

Of course the explanation of Ord.No. 17/10 concerning a 2 mm steel drive wire in acrobatics applies not only for fuselages, it is similar for training helicopters.
When you convert a trainer you use the existing tail boom. Main gearbox and tail gearbox have to be provided with a claw connector 49/12 each.
Models over a certain age should be checked whether the present tail rotor connector has a shaft of 5 mm OD. If not you will require a bevel gear 95 and two ballraces 96/1.

• Stainless steel drive wire
• for 20 mm Ø tail boom
• with 0.8 mm wall thickness
• complete as shown